Your self-storage lighting specialists!

ArcLume Architectural LED Wall Pack
  • ArcLume Architectural LED Wall Pack
ArcLume Architectural LED Wall Pack - is currently on backorder. You may still purchase now though and we'll ship as soon as more become available.
Description
Specifications
Downloads

The ArcLume LED wallpacks replace 100W to 250W metal halide wall-mounted fixtures while consuming up to 70% less energy and operating for 50,000 hours. The expected service life is more than 13 years of nighttime use.

Generally ships within 48 hours. Some configurations may take up to 5 days. We only ship within the contiguous "lower 48" states. We do not ship to Alaska, Hawaii, or out of country.

HOUSING / LENS / OPTICS Die-cast aluminum housing in bronze finish with clear polycarbonate lens. Thermally efficient LED-specific housing with integrated heat sink fins provides for cooler operation and maximum LED operating life. Weatherproof silicone gasketing around lens and between backplate and housing seals out contaminants. 1.75" deep back plate DBS (standard 85W; optional on 30W and 58W units) provides an additional 1/2" top/bottom NPT as well as back knockout. Angled LED mounting surface combined with integral 95% reflective MIRO 4™ reflector provides significantly more forward throw illumination than typical full cutoff LED wallpacks. Distribution is NEMA Type IV short.

LEDS Available in 3 light levels; 1900 lumens (30W), 3900 lumens (58W), and 5800 lumens (85W) at 4000K CCT; >80 CRI. LED operating life 50,000 hours L70. Light engines consist of 1, 2, or 3 chip-on-board arrays mounted direct to thermally efficient aluminum housing.

ELECTRICAL 120 - 277 VAC power supply with surge protection. Power factor is >0.9. Power supply is mounted in direct contact with aluminum housing for cooler operation and longer life. Drive current is 700 mA. 30W units use one power supply; 58W units use two, and 85W units use three.

ACCESS / WIRING Housing includes 1/2" top/bottom NPT. Specify option DBS (standard on 85W units) for a 1-3/4” deep die cast back plate with 1/2” top/bottom NPT and back center knockout for conduit feed or sensors.

MOUNTING Standard backplate for mounting over a 4" recessed junction box. Backplates and housing utilize installed brackets to hold fixture during wiring. Back plate includes center knock out for conduit access and drill points. The recommended wall mounting height of the of the ARCL LED wallpack is 10 ft. to 24 ft. Fixture is designed to be installed in the downward facing position only.

LISTINGS UL Listed wet location, DesignLights Consortium® (DLC) qualified.

WARRANTY 5 years